Printronix P8000 Series Cartridge Ribbon Printer - Manual (Page 134)

134
Chapter 4 EMULATION Menu
Autowrap
This option defines the printer actions when print data is received past the
forms width setting.
• With LF+CR (factory default). Performs an automatic carriage return and
line feed when data is received past the forms width.
• With CR . Performs an automatic carriage return (without line feed) when
data is received past the forms width.
• Disable . Discards any data past the forms width.
Define LF Code
The Define LF code option controls the action of the printer when it receives a
Line Feed code (hex 0A) from the host computer. If this feature is enabled,
each time the printer receives a Line Feed, it inserts an additional Carriage
Return code (hex 0D) into the data stream. This feature can be used in most
installations, but it is required if the host computer does not send Carriage
Returns to the printer.
• LF = CR + LF (factory default). Adds an extra Carriage Return with each
Line Feed.
• LF = LF . Does not add a Carriage Return with a Line Feed.
Printer Select
• Disable (factory default). Ignores the ASCII DC1 and DC3 control codes.
• Enable . Disables the printer when a DC1 control code is received, and
enables the printer when a DC3 control code is received.
Alt. Set 80-9F
• Control Code (factory default). Interprets data in the range of hex 80
through hex 9F as a control code.
• Printable . Prints data in the range of hex 80 through hex 9F.
Emulation Extend
• Disable (factory default). Does not select the extension command.
• Enable . Selects the extension command (ESC 4/ESC 5 to select/cancel
Italic Printing and ESC SP to select Intercharacter Spacing).