397
HAMMER COIL BAD, ###, 300
HAMMER DRIVER CIRCUIT BAD*, 300
HAMMERBANK NOT INSTALLED*, 300
HMR BANK FAN FLT, 300
H-Series, 310
H00: PCI SLOT ?, 299, 322
H01: PCI J12, 299, 322
ILL EXT BUS ACC *, 300
ILL NVM VALUE 5, 301, 323
ILL NVM VALUE 6, 301, 323
ILL NVM VALUE 7, 301, 323
ILLGL OPR ACCSS *, 301
INITIALIZING.., 301, 323
INTAKE FAN CHECK, 301, 323
INTERRUPT UNUSED VECTOR 00, 301, 323
LO DRV. SHORT *, 301
LOAD PAPER, 301
LOADING PROGRAM FROM
PORT XX%, 302, 323
LOADING PROGRAM INTO FLASH, 302, 324
NEW SPX DETECTED, 302, 324
NON VOLATILE MEMORY FAILED, 302, 324
ONLINE, 302, 324
PANEL BAD CHECKSUM, 302, 324
PAP BAD TABLE *, 302
PAP FIFO OVERFL *, 302
PAP FIFO UNDRFL *, 302
PAP ILLGL ST *, 303
PAP INVLD CMD *, 303
PAP INVLD PARM *, 303
PAPER REQUESTED, 303
PARAMETER ERROR*, 324
PARITY ERROR, 303
PLAT DRVR CIR, 324
PLAT INV CMD *, 303
PLAT INV PARM *, 303
PLAT INV STATE *, 303
PLEASE WAIT...RESET IN
PROGRESS, 303, 324
POWERSUPPLY HOT *, 303
PRINTER HOT *, 303
PRINTER UNDER REMOTE
CONTROL, 304, 324
PROCESSOR HALTED
EC_FAULT_RTSYS2, 304, 324
PROTECTED INSTR *, 304
PS/PDF ERROR CHECK ERROR, 304
PS/PDF ERROR DICTIONARY ERROR, 304
PS/PDF ERROR INVALID ACCESS, 304
PS/PDF ERROR I/O ERROR, 304
PS/PDF ERROR JOB ABORTED, 305
PS/PDF ERROR STACK ERROR, 305
PS/PDF ERROR SYNTAX ERROR, 305
PWRSUPP VOLT *, 305
REMOVE USED SPX, 305, 324
RESTORING BOOT CODE, 305, 324
RIB INVLD CMD*, 305
RIBBON STALL, 305
RIBBON UNDER 2%, 306
SCS COMMAND ERROR, 325
SD CARD ERROR, 306, 325
SD FILE EXISTS, 306
SD FILESYS FULL Delete Files, 306
SD FILESYS FULL File Too Big, 306
SD FILESYS WRITE, 306
SD INSERTED, 306
SD NOT FOUND, 306
SD READING, 306
SD REMOVED, 306
SD WRITE FAIL WRITE PROTECTED, 307
SD WRITING, 307
SDSC CARD NOT SUPPORTED, 307, 325
SECURITY KEY NOT DETECTED, 307, 325
SECURITY VIOLATION, 307, 325
SF ERROR, 307, 325
SHUTL INV CMD *, 307
SHUTL INV PARM *, 307
SHUTL OVR SPEED*, 307
SHUTTLE JAM, 307
SHUTTLE STALL, 308, 325
SHUTTLE TYPE NOT SUPPORTED*, 308
SOFTWARE ERROR* CYCLE POWER, 308