Printronix P8000 Series Cartridge Ribbon Printer - Manual (Page 142)

142
Chapter 4 EMULATION Menu
DBCS Compressed (H-Series)
This parameter allows you to specify the appearance of ASCII/DBCS
characters in DBCS mode. It is not applicable for the H-Series Hangul printer.
• Disable (factory default)
• Enable . Both the DBCS and ASCII characters will be printed as half-width
of their original size.
Font Scale (H-Series)
This parameter allows you to specify the appearance of the font size. It is
applicable for the H-Series GB printer.
• Standard (factory default). The character prints as 24 x 24 cell size.
• 16 x 24 . The character prints as 16 x 24 cell size.
Encoding (H-Series)
• Address Table (factory default). Specifies the address table supported.
GB18030 is for Hanzi GB printer.
BIG5 (factory default), CNS , TCA , ETEN , IBM5550 , TELETEXT ,
BIG5+ , BIG5E , and HKSCS are for Hanzi Big5 printer.
KSC5601 is for Hangul printer.
Shift-JIS is for Kanji printer.
• UTF-8 . The printer takes in UTF-8 data stream and prints out according to
Unicode format.
Taller 15 CPI (H-Series)
This parameter allows you to specify the appearance of ASCII characters as
15 CPI in ASCII mode.
• Disable (factory default). The characters in 15 CPI appear shorter than
other CPIs such as 10 CPI.
• Enable . The height of 15 CPI characters is the same as other CPIs such
as 10 CPI.
Horizontal Expnd (H-Series)
This parameter allows you to specify dot character horizontal expansion for
both ASCII and DBCS characters in DBCS mode.
Vertical Expnd (H-Series)
This parameter allows you to specify dot character vertical expansion for both
ASCII and DBCS characters in DBCS mode.