Printronix P8000 Series Cartridge Ribbon Printer - Manual (Page 364)

364
Appendix F The PTX_SETUP Commands
CONFIG OVERLAY Cfg This command overlays the
configuration data that follows on
existing configuration Cfg. Cfg must
be 1-8 (or END). If Cfg does not
exist then command is treated the
same as DOWNLOAD.
RESET Reboots the printer.
GET_NAMES “Port” This command uploads the names
of the configurations to the port
specified by Port. Port must either
be “1284” or “SERIAL”.
SET_NAME Cfg This command downloads a name
for the configuration specified by
Cfg . Cfg must be 1-8.
CLEAR_NAMES This command resets all of the
configuration names to their default
values.
MPI_SELECT MPI This command selects the active
Management Protocol Interface
(MPI). Currently there are two
selections “UCP” and “PXML”.
PNE_PORT Port This command selects the port that
the PNE will use to communicate to
the printer.
The valid ports are:
• DISABLE
• ETHERNET
• USB
NOTE: If ETHERNET is selected
but not enabled, the
selection will revert to
DISABLE.
Table 27. PTX_SETUP Commands (Non-Platform Specific) (continued)
Command Sub-Command Parameter Description