Printronix P8000 Series Cartridge Ribbon Printer - Manual (Page 209)

LG Emulation
209
Horiz Forms
• Left Mgr 0.00 (factory default). This sets the left margin for the forms.
You must specify the left margin in 1/10 inch increments, from 0 to 13.1
inches. The default value is 0. Press the right arrow to increase the value,
left arrow to decrease the value, and ENTER to change units. The
margins will automatically adjust so that the left and right margins do not
cross each other.
• Right Mrg 13.2 . This sets the right margin for the forms. You must specify
the right margin in 1/10 inch increments, from 0.1 to 13.2 inches. The
default value is 13.2. Press the right arrow to increase the value, left
arrow to decrease the value, and ENTER to change units. The margins
will automatically adjust so that the left and right margins do not cross
each other.
Autowrap
This parameter determines if text will wrap to the next line when the line of
text exceeds the right margin.
• No (factory default). Any print data received past the forms width setting
is discarded.
• Yes . An automatic carriage return and line feed is performed when data is
received past the forms width setting.
CR
This option controls the action of the printer when it receives a Carriage
Return code (hex 0D) from the host computer. If this feature is enabled, each
time the printer receives a Carriage Return, it inserts an additional Line Feed
code (hex 0A) into the data stream. Do not use this feature if the host
computer sends line feeds to the printer.
• = CR (factory default). Does not insert an extra line feed after each
carriage return.
• = CR + LF . If this feature is enabled, each time the printer receives a
Carriage Return, it inserts an additional Line Feed code (hex 0A) into the
data stream. (Do not use this feature if the host computer sends Line
Feeds to the printer with each Carriage Return.)
LF
This parameter forces the printer to insert an automatic Carriage Return code
into the data stream whenever a Line Feed code occurs. This can be used in
most installations, but it is required if the host computer does not send
carriage returns to the printer.
• = LF (factory default). Does not perform an automatic carriage return. The
next print position will be the current print position of the next line.
• = CR + LF . Each time the printer receives a Line Feed, it inserts an
additional Carriage Return code (hex 0D) into the data stream. This
feature can be used in most installations, but it is required if the host
computer does not send Carriage Returns to the printer.