Printronix P8000 Series Cartridge Ribbon Printer - Manual (Page 75)

P8000 PCL-II Firmware
75
P8000 PCL-II Firmware
OFFLINE
CONFIG.
CONTROL
page 91
HOST
INTERFACE
page 93
Load Config.
Save Config.
Print Config.
Delete Config.
Power-Up Config.
Protect Configs.
Name Configs
Reset Cfg Names
Auto Save
Active Host
Auto Switching
Centronics 1
Serial
IEEE 1284 1
USB
NETWORK
SETUP 1
page 105
Ethernet Address 1
Ethernet Params 1
QUICK
SETUP
page 82
Active Host
ZTP DataTime 6
ZTP WaitTime 6
ZTP TearDist
6
ACTIVE EMULATION
PGL SFCC 2
VGL SFCC 3
Active Protocol 4
Form Length
4
Form Width 4
Select CPI 4
Select LPI 4
P-Series SFCC 4
Page Length Rep.
5
Max Line Width 5
LPI Adjust 5
Ribbon End Point
Save Config.
Power-Up Config.
Open Platen @ BOF
Slow Paper Slew
EMULATION
page 111
ACTIVE EMULATION
LinePrinter+
4
IGP/PGL 2
IGP/VGL
3
PCL-II 5
PRINTER
CONTROL
page 216
ZTP SETTINGS 6
Ribbon End Point
Open Platen @ BOF
Bar Code Quality
Tear Bar Dist. 7
View Function
Unidirectional
Display Language
Panel Display
DIAGNOSTICS
page 238
Printer Tests
Test Width
Phase Value
Paper Out Dots
System Memory
Print Statistics
Software Build
Feature File 8
Shuttle Type
Auto Dump
Printer Mgmt
ADVANCED
USER
page 220
Hex Dump Mode
Power-up State
PMD Fault
Power Stacker 1
Auto Elevator 1
Auto Locking
Main File System
SD File System 1
Shuttle Timeout
Slow Paper Slew
Alarm
Power Saver Time
Pwr Save Control
Cancel Key
Rcv. Status Port
Ret. Status Port
Set Lock Key
RBN Low Warn@
RBN Low Action
RBN End Action
Print Energy 9
Disp. Intensity
1 If installed.
2 If PGL is selected from the ACTIVE EMULATION menu.
3 If VGL is selected from the ACTIVE EMULATION menu.
4 If LP+ is selected from the ACTIVE EMULATION menu.
5
If PCL-II is selected from the ACTIVE EMULATION menu.
6 Available for Zero Tear Pedestal printers only.
7 Available for pedestal printers only.
8 If a Feature File has been downloaded.
9 Available for 1000 lpm printers only.