Snap-On 5000-3 - Manual (Page 12)

FUNCTIONAL DESCRIPTION AND SPECIFICATIONS CHAPTER 2
Display
A 240 x 64 Full-featured Graphic LCD is used to provide versatile and clear displays of
system menus as well as measurements. Characters and symbols are displayed in
different fonts:
• Maximum transducer range in the selected UNITS of measure.
• The number of the present data memory location.
Front Panel Membrane Cursor and Function Keys
The SURETEST is supported by a powerful Graphic User Interface (GUI). Set up,
Command, or Control is done by selecting the appropriate Action Item on one of the
provided Menus. Front Panel Membrane Cursor and Functions keys are defined to guide
the User in selecting an Action Item.
There are 6 function (soft) keys:
F1 through F6 . Their respective uses are clearly
indicated on the LCD.
To select an Action Item, the User simply presses a Function Key (F1-F6) to get to a
Menu, uses a Cursor Key to move to the Item, then hits ‘ENTER’ .
In addition to the
‘ENTER’ key, there are 4 Cursor Keys : Up (
↑), Down (↓),, Left
(
←), Right (→). The GUI also provides Prompts to further assist the user in navigating
the Menus.
Power Up Sequence
Upon power up, the SURETEST automatically performs Self-tests and displays the
results. Any detected non-functional hardware will be reported on the LCD. If a 4-in-1
transducer is connected, the SURETEST performs ZEROTARE, then displays the
following default menu while continuously checking for any activity from an input
transducer :
The user can either press F1 to display previously collected data (if any) or enter Setup
Mode, F2. Any detected torque measurement will cause the SURETEST to enter
Measurements mode where the following menu is displayed:
2-3