Snap-On 5000-3 - Manual (Page 60)

MANUAL LOADER CHAPTER 6
Torque Tester/Calibrator
Figure 6-1: Installation multiple transducers
A- Quick release pin (Transducer)
B- 4-in-1 Transducer Standoff
C- 600TL (Manual Loader)
D- Side thumb screw
E- 4-in-1 Adapter Bracket
F- Multiple
Transducers
G- Drive Adaptors
H- SURETEST
I- Top thumb screw
J- Tube, Load (Part of rest assembly)
K- Rest,
Adjustable
L- Reaction Slide Assembly
M- Safety shield
N- Hand
Crank
P- Extendable Reaction Bar
R- Linear Bearing Assembly
Quick Release Pins
Four quick release pins must be installed to lock the standoff to the adapter bracket and loader.
Slide thumb screw
Two knobs on the bracket are used to align the selected transducer over the loader drive. Tighten
the left knob first, then the top knob. The wrench or driver to be tested is then coupled to the
selected transducer using an internal-internal adapter.
4-in-1 Adapter Bracket
Holds the 4-in-1 transducer horizontal to the loader.
IMPORTANT
Adjustable rest on the load tube may be raised or lowered to level the wrench prior to
loading. It is normal for the wrench handle to rise as it levels itself under load.
6-2