Rainbow Electronics MAX16066 - Manual (Page 4)

12-Channel/8-Channel, Flash-Configurable System
Managers with Nonvolatile Fault Registers
MAX16065/MAX16066
4 ______________________________________________________________________________________
ELECTRICAL CHARACTERISTICS (continued)
(V CC = 2.8V to 14V, T A = -40NC to +85NC, unless otherwise specified. Typical values are at ABP = DBP = V CC = 3.3V, T A = +25NC.)
(Note 1)
PARAMETER SYMBOL CONDITIONS MIN TYP MAX UNITS
OUTPUTS (EN_OUT_, RESET, GPIO_)
Output-Voltage Low V OL
I SINK = 2mA 0.4
V I SINK = 10mA, GPIO_ only 0.7
V CC = 1.2V, I SINK = 100μA (RESET only) 0.3
Maximum Output Sink Current
Total current into EN_OUT_, RESET,
GPIO_, V
CC = 3.3V
30 mA
Output-Voltage High (Push-Pull) I SOURCE = 100μA 2.4 V
Output Leakage (Open Drain)
1
μA
EN_OUT1–EN_OUT8 = 13.2V 5
OUT_ Overdrive (Charge Pump)
(EN_OUT1–EN_OUT8 Only)
I GATE_ = 1μA 10 11 13 V
OUT_ Pullup Current (Charge
Pump)
I CH_UP During power up, V GATE = 1V 2.5 4 μA
SMBus INTERFACE
Logic-Input Low Voltage
V IL Input voltage falling 0.8 V
Logic-Input High Voltage V IH Input voltage rising 2.0 V
Input Leakage Current IN = GND or VCC -1 +1 μA
Output Sink Current V OL ISINK = 3mA 0.4 V
Input Capacitance C IN 5 pF
SMBus Timeout t TIMEOUT SCL time low for reset 25 35 ms
INPUTS (A0, GPIO_)
Input Logic-Low
V IL 0.8 V
Input Logic-High V IH 2.0 V
WDI Pulse Width t WDI 100 ns
MR Pulse Width t MR 1 μs
MR to RESET Delay 0.5 μs
MR Glitch Rejection 100 ns
SMBus TIMING
Serial Clock Frequency
f SCL 400 kHz
Bus Free Time Between STOP
and START Condition
t BUF 1.3 μs
START Condition Setup Time t SU:STA 0.6 μs
START Condition Hold Time t HD:STA 0.6 μs
STOP Condition Setup Time t SU:STO 0.6 μs
Clock Low Period t LOW 1.3 μs
Clock High Period t HIGH 0.6 μs
Data Setup Time t SU:DAT 100 ns