SENA Parani-SD1100 - Manual (Page 10)

10
2. Getting Started
This chapter describes how to set up the Parani-SD1100 for the first time.
- 2.1 Panel Layout explains the panel layout.
- 2.2 connecting the Hardware describes how to connect the power, the serial device to the Parani-
SD1100.
Following items are required to get started:
- One DC power adapter, USB power cable or DC power cable (included in the package).
- RS232-422/485 Converter
Users may need to use specific type of adapter to fit for the RS232-422/485 converter he may have. If
users’ converter is DB9 female type to connect to SD1100, then he may not need additional adapter.
The following picture is an example of the adapter that is fir for RS232-422/485 Converter whose
connector for the SD1100 wiring has a terminal block interface. If the connector with same type has
the different location of the serial signals, it needs to be wired properly according to the serial signals.
* Users need to wire the serial signals matching the Pin outs of SD1100 to make RS422/485
communication possible. (Refer to A.1. Serial Port Pin Outs) User can also do it using the accessory
with DB9-Terminal Block type as below.
Figure 2-1 DB9-Terminal Block
- One PC with RS232 serial port.
- Terminal emulation program running on the PC.
2.1. Panel Layout
This section describes the panel layout of the Parani-SD1100.
Figure 2-2 The panel layout of Parani-SD1100