SENA Parani-SD1100 - Manual (Page 16)

16
3.8. Remote Configuration
Parani-SD1100 supports remote configuration. After connecting to the Parani-SD1100 through
Bluetooth, before sending any other character, send three escape character (default :+). Then, the
Parani-
SD1100 will enter remote configuration mode and print “Please Enter Password”. You have to
enter the password with “AT+PASS” command within 2 minutes. After the password authentication,
you are able to enter any at command except “ATH”, “ATO”, “ATD”, “AT+BTSCAN”, “AT+BTINQ?” and
“AT+BTCANCEL”. The default password is “0000” and it is configurable with “AT+CHPASS” command.
Example of remote configuration:
Example of remote configuration mode.
3.9. Software and Utility
This configuration software and utility for firmware update is included with the product, which also can
be downloaded from
http://www.sena.com .
Table 3-10 Configuration Software
Software Purpose Operating System
ParaniWIN Configuration MS Windows 98SE or Higher
ParaniMultiWizard Multiple Connection Configuration MS Windows 98SE or Higher
ParaniUpdater Firmware Update MS Windows 98SE or Higher
3.10. ParaniWIN
ParaniWIN is a program that runs on Microsoft Windows for the configuration of Parani-SD1100. Install
ParaniWIN on your computer. Plug a Parani-SD1100 into the serial port of the computer to use RS232
 RS422/485 converter (SENA LTC 100) and turn on the power. Run ParaniWIN.
CONNECT 000195000001
+++
Please Enter Password
AT+PASS=0000
Remote Configuration Enabled
AT+BTINFO?
000195000001,SD1100v1.1.1-095515,MODE0,CONNECT,0,0,HWFC