SENA Parani-SD1100 - Manual (Page 15)

15
Step 1. Turn on SD1 and SD2 and reset both of them by pressing Factory Reset Button.
Step 2. Press the Pairing Button of SD1 for 2 seconds until Connect LED blinks 3 times every 3
seconds. Keep the power ON.
Step 3. Press the Pairing Button of SD2 for 2 seconds until Connect LED blinks 3 times every 3
seconds. Now press again the Pairing Button for 2 seconds until Connect LED blinks every second.
Step 4. Wait for SD1 & SD2 to connect to each other until the Connect LED’s of SD1 and SD2 blink
every 1 second. It takes about 10 seconds to make a connection. If there are many Bluetooth
devices nearby, it may take longer.
Step 5. Turn SD1 off and on. Connect LED blinks twice in green every 3 seconds.
Step 6. Turn SD2 off and on. Connect LED blinks in green every second.
Step 7. Now SD1 and SD2 are configured to make automatic connection to each other, whenever they
are powered on.
Using a pair of Parani-SD1100 in this fashion is similar to that of using a wireless serial cable.
* Note: When using the pairing buttons, the Command Response option will be deactivated
automatically. The Parani-SD1100 will not send the response messages such as OK, ERROR,
Connect and Disconnect.
Table 3-8 Pairing Process by Pairing Button
SD1 Status LED SD2 Status LED
1. Factory reset Mode0 Standby LED turns on. 1. Factory reset Mode0 Standby LED turns on.
2. Push pairing
button Mode3 Connect LED blinks 3
times every 3 sec. 2. Push pairing
button Mode3 Connect LED blinks 3
times every 3 sec.
3. Push pairing
button again Mode1 Connect LED blinks
every second.
4. Connected Slave Connect LED is lit in
green 4. Connected Master Connect LED is lit in
green
Using pairing button, users can make a pairing connection between a Parani-SD unit and other
Bluetooth devices.
Step 1. Turn on SD1 and reset it by pressing Factory Reset Button.
Step 2. Press the Pairing Button of SD1 for 2 seconds until Connect LED blinks 3 times every 3
seconds. Keep the power ON.
Step 3. Users can discover and connect to SD1 by using the software or user interface of other
Bluetooth device that they want to connect from.
Step 4. When they are connected, the Connect LED of SD1 blinks every 1 second.
Step 5. Turn off and on. Connect LED blinks twice in green every 3 seconds.
Step 6. Now SD1 is waiting for a connection from the last connected Bluetooth device. The last
connected Bluetooth device can connect to SD1.
Table 3-9 Pairing Process with other Bluetooth device by Pairing Button
SD1 Status LED Other Bluetooth Device Status
1. Factory reset Mode0 Standby LED turns on.
2. Push pairing button Mode3 Connect LED blinks 3
times every 3 sec.
3. Inquiry and connect to SD1
4. Connected Slave Connect LED is lit in
green 4. Connected Master