SENA Parani-SD1100 - Manual (Page 19)

19
Figure 3-6 Device Setting Window
Parani-SD1100 supports two security options, Authentication and Encryption. If you enable the
Authentication option, you must also enter a Pin Code value. If the authentication is enabled, the
connection, between the Master and Slave device must share the same Pin Code. In case that Parani-
SD1100 connects to another Bluetooth device, that requires authentication, you must know the other
device’s Pin Code. In general, most Bluetooth devices have a pincode of 1234 or 0000.
If you check Encryption option, the Parani-SD1100 will encrypt packets and sent to the device. The
Encryption options works well in case that only one of the devices between Master and Slave use the
Encryption option.
Parani-SD1100
has 4 response messages, ‘OK’, ‘ERROR’, ‘CONNECT’, and ‘DISCONNECT’. In
some cases, these responses can affect the host system unexpectedly. To prevent this, user can set
the Command response to ON or OFF.
If dipswitch for UART Configuration is put at 9600-8N1, Baudrate, Parity and Stopbit cannot be set.
They are configurable at SWConfig mode. The options which are not configurable are deactivated
according to the model of Parani series.
Click [Apply] button to apply any changes made to the Parani-SD1100.
Connection(out) icon will show the following window to search and connect other Bluetooth devices.