SENA Parani-SD1100 - Manual (Page 47)

47
C.6. S11: Enable Escape (default 1)
S11=0, Parani-SD does not allow escape sequence characters. The operation status of Connect
cannot be changed to Standby. Since the Parani-SD skips the process of detecting escape
sequence characters, more efficient data transmission can be had.
S11=1, Parani-SD allows for the escape sequence character. Whenever it is needed, the Connect
status can be changed to Standby.
C.7. S12: Clear Data Buffer When Disconnected (default 1)
S12=0, Parani-SD does not clear the data buffer received from host system when disconnected.
S12=1, Parani-SD clears the data buffer when disconnected.
C.8. S22: Faster Connection (default 0)
S22=0, none
S22=1, page scan
S22=2, inquiry scan
S22=3, page/inquiry scan
Connecting time is average 1.5sec faster than normal mode.
C.9. S23: Intercharacter Timeout Setting (default 0)
S23=0 : Not used
S23=1 : 1 x S26
S23=2 : 10 x S26
S23=3 : 100 x S26
C.10. S24: Maximum Number of Inquiry Result (default 15)
The maximum number of inquiry list can be controlled. If value is 0, maximum number of
inquiry list is limitless.
C.11. S26: Intercharacter Timeout (default 0)
This value describes time interval between characters used to separate the data from serial port. If
there is no more data coming from serial port in this value, data is sent to client.
S23=1 x S26=50 : Timeout-> 50msec
S23=2 x S26=50 : Timeout-> 500msec
S23=3 x S26=3 : Timeout-> 300msec
* When 10 bytes data are sent every intercharacter timeout, they are sent separately by 10 bytes at
the optimal value. If the intercharater timeout is set below the optimal value, the date will be put
together and sent by 20, 30, 40 bytes or more.
C.12. S28: Escape Sequence Character (default 43)
The decimal number of the ASCII code of escape sequence character can be controlled. The initial
value is 43, the ASCII code of ‘+’.
Intercharacter Timeout * Optimal Value(S23 x S26)
50ms 180
100ms 235
200ms 340