SENA Parani-SD1100 - Manual (Page 44)

44
B.3.31. AT&V
Response  S0:m0;S1:m1; …Sn:mn
 OK
Purpose Display all the S-registers
Description All parameters are stored at S-register in flash memory. These values are sustained until
hardware reset.
B.3.32. AT+PASS=$string
Response Remote Configuration Enabled
Purpose Input password in remote configuration mode.
Parameters $string= Password (Default=”0000”)
Description Input password for authentication in remote configuration mode.
Example AT+PASS=1234
B.3.33. AT+CHPASS=$string
Response  OK
Purpose Change password used in remote configuration mode.
Parameters $string= New password
Description Change password used in remote configuration mode. Password length is up to 8.
Example AT+CHPASS=12345678
B.3.34. ATSnn? 
Response  value
 OK
Purpose Display a given S-register
Parameters nn= Address of S-register
Description A specific S-register will be displayed.
B.3.35. ATSnn=mm
Response

OK

Purpose Change S-register value
Parameters nn= Address of S-register
mm= New value of S-register
Description Some S-registers are optimized for the overall performance and protected and cannot be
changed. When users try to change these S-
registers, response is ‘ERROR’.
For details of S-register, refer Appendix. B.
Example ATS10=0