GE Industrial Solutions WattStation Pedestal EVSE Charger Operation and Maintenance - Manual (Page 4)

WattStation™ EV Charger User Manual
4 GE Energy ©2012 GE Company All Rights Reserved
Safety and Compliance
1.1.1 Important Safety Instructions
• Read all the instructions before using this product.
• Do not put fingers into the electric vehicle connector.
•
Do not use this product if the flexible power cord or EV cable is frayed, has broken insulation, or
shows any other signs of damage.
• Do not use this product if the enclosure or the EV connector is broken, cracked, open, or shows
any other indication of damage.
• To reduce the risk of fire, replacement fuses should be of the same type and rating.
• Risk of Explosion. This equipment has internal arcing or sparking parts which should not be
exposed to flammable vapors. It should not be located in a recessed area or below floor level
• This device is intended only for charging vehicles not requiring ventilation during charging
• The Electric Vehicle Supply Equipment (EVSE) must be connected to a centrally grounded system.
The ground conductor entering the EVSE must be connected to the equipment grounding lug
inside the charger. This should be run with circuit conductors and connected to the equipment
grounding bar or lead on the EVSE. Connections to the EVSE are the responsibility of the installer
and purchaser, not GE and must comply with all applicable electrical codes and ordinances.
• Risk of electric shock. Do not remove cover or attempt to open the enclosure. No user serviceable
parts inside. Refer servicing to qualified service personnel.
WARNING: