GE Industrial Solutions WattStation Pedestal EVSE Charger Operation and Maintenance - Manual (Page 8)

WattStation™ EV Charger User Manual
8 GE Energy ©2012 GE Company All Rights Reserved
The LED Ring and fault icon will flash RED when the jumper is connected to the DC harness.
After the IP address is reset, the customer must power down the EVSE, remove the
jumper cable, and reboot.
3.1.9 Removable Top Assembly
The plastic top assembly of the EVSE can be removed by an electrician or installer in order to perform
maintenance or upgrades. Opening the access door is required to allow top assembly removal.
3.1.10 LED Ring
A LED ring will surround the top portion of the EVSE. The LED ring changes color depending on the
EVSE state. Table 3.1 shows the LED ring states and colors. The LED ring can be enabled or disabled
by the EVSE owner via the configuration tool. When the LED Ring is disabled, the LED will still flash
once when initially connected or disconnected from a vehicle
LED Ring state and color
TTaabbllee –– 33..11
WARNING: The customer must remove power to the EVSE before
attempting to open the access door.