GE Industrial Solutions EntelliGuard TU Conversion kits User Manual
Page 6
Advertising
6
SECTION 2 Installation instructions for “RELT wire harness kit” (Catalogue Number – GTURHA)
For GE type AK, AKT, AKS, AKU, AKJ, AKR, AKRU, AKRT, AKJT, AKW
Low Voltage Power Circuit Breakers.
Installing the RELT wire harness
1. Remove the existing MVT trip unit from breaker by pressing
the lever on side of trip unit mounting plate and gently pull
the trip unit toward yourself as facing the breaker,.
2. Loosen the three screws with screwdriver as shown in
figure 3.
Save the screws, washer and nut for mounting back the
plate later.
3. Rotate the mounting plate from frame, being careful not to
pull on existing wires.
Figure 2
Figure 3
Figure 4
Advertising