GE Industrial Solutions EntelliGuard TU Conversion kits User Manual
Page 8
Advertising
8
6. Tie these extra four wires (or 6 wires) with other
wires at back of 36-pin connector properly.
Inspect the 36-pin connector from front side of
plate for extra four connectors installed.
7 Take the earlier removed sets of screws, washers and
nuts.
Install the mounting plate again on frame by
tightening the screws at three locations.
9. Route the RELT & power supply wire harnesses as
instructed in following section 2 to section 6 depends
on breaker type.
Figure 9
Figure 10
Advertising