GE Industrial Solutions GPS4827 User Manual
Page 41
Galaxy Power System GPS4827
39
Data Switch Card
Step
Action
NOTE:
Installation or replacement of this pack can be done “hot”; power removal
is not necessary.
2.
Install two 407882133 standoffs on the BSJ intelligent board. Screw
threads are protruding just below TB1, located at the upper left hand
corner of the MCR1 board.
3.
Place BSW pack inside the 847950938 insulator.
4.
Plug BSW pack into the P205 connector on the BSJ intelligent controller
board
5.
Secure the BSW board to the standoffs with two 900562208 screws.
NOTE:
To install the Data Switch Extension board, please see the User’s Guide for
Millennium II Controller Advanced Features manual.
Alarm Termination Board
Alarm Termination board options provide for wire wrapped or insulation displacement
(punch down) terminations. The Alarm Termination Board for a specific application
may require field installation. To do so, perform the following steps:
Step
Action
1.
In the upper right hand corner of the MCR1 board, find the alarm board
already installed.
2.
Remove the two screws holding the board at the top.
3.
Holding the board on both sides, slowly, but firmly, remove the alarm
board from the P8 connector.
4.
Unpack the new board from its box, carefully observing proper ESD
procedures.
5.
Connect the alarm board to P8 and press down firmly, until the board is
seated.
6.
Secure the alarm board at the top using the two screws removed earlier.