GE Industrial Solutions EPM1500 Single Point Submetering System User Manual
Page 20
Advertising
2–10
EPM 1500 SUB-METER – INSTRUCTION MANUAL
CHAPTER 2: INSTALLATION
Z
Take the black, red, blue and white (if available) #12 AWG feeder
phase tap wires and run them to
⇔A, ⇔B, ⇔C, and N (if available)
respectively (see Internal Fuse Block on page 2–11).
Z
Plug the fuse block into the meter head and hang the meter head
on the back box.
Z
Close up the breaker panel until the certification inspector arrives.
Advertising