GE Industrial Solutions 6KCV300lNS - Manual (Page 26)

GEI- 100445
10.0 SERVICE ERROR CODES AND OPERATION RESULT
The following table shows the different error codes that may occur during the execution of a service. These
codes are contained in the “Additional error codes” field.
RESULT CODES
OK no error
Attribute Access denied
Type value error
Parameter not exist
Reserved
Reserved
Control Access denied
Reserved
OOOOH
0005H
0001 H
0006H
0003H
0004H
Destination option not exist
Parameter Access Conflict
Value out of the maximun ranae
0012H
Value out of the minimun range
Value not supported
Parameter Confiauration Conflict
Command Submitted
Reserved
Unknown Command
Read only Parameter
Write not allowed
Value out of constant limits
State not correct
Password
Type Unknown
Hardware Fail
Checksum Fail
Reserved
Reserved
NOK generic
User defined
0013H
0016H
0018H
001
001 CH
001 DH
001 EH
0030H
0031 H
001 FH-007CH
OOFFH
01 OOH-FFFFH