GE Industrial Solutions 6KCV300lNS User Manual
Page 5
S
Mounting
The
cards are provided with a kit made up of 4 spacers, 4 screws, washers and a 40-pole fiat
cable with connectors.
1. Switch the drive off.
2. The
card must be fixed with the screws and the spacers to the regulation card.
Hereby we are representing as an example the card R-TPD3.
Connectors linking the Bus are placed in the same direction of the terminals belonging to the regulation card.
3. The flat cable is connected to the connector
already existing on the cards.
4. The dip switch
determines the Slave
identification code; for
card
this code is
(Slave on local Bus PCP)
and it absolutely can not be changed
otherwise the Master will not be able to
identify the card correctly .
5. Link the input local Bus cable to the
connector XIN and eventually the output
cable to the connector XOUT.
6. Switch on the drive and supply the local
Bus.
7. The
and HO light up.
8. The LED H6 lights up when the Bus is
active.
The LED H3 lights up when a PCP service
is required.