Xylem CVD-2000 CELLULAR AUTODIALERS - Manual (Page 15)

Global Water
800-876-1172
• globalw.com
- 15 -
2. STEP 2
(a) The LCD will read: SELECT: 1-4
0(DONE)
(b) Enter the channel you wish to program (1-4).
g) Enable/Disable
1. STEP 3
(a) The LCD will read: CH X: ENABLE
1(YES) 2(NO)
(“CH X” being the channel selected)
(b) Press “1” to enable the channel. Press “2” to disable the channel.
h) Exit/Entry Delays
Capable of programming up to a maximum of 3 minutes and 20 seconds each.
1. STEP 4
(a) The LCD will read: CH X: EXIT DELAY
1(YES) 2(NO)
(b) Proceed with (i) if you wish to program an exit delay.
(c) Proceed with (ii) if you do not.
(i) To program exit delay, press “1”.
(ii) The LCD will read: ENTER 0-199 THEN
PRESS *
Enter the digits corresponding to the number of seconds you wish
to install. (For example, press “120” then press “*”, if you wish to
install a 120-second exit delay).
(d) If you do not wish to program an exit delay, press “2”.
2. STEP 5
(a) The LCD will read: CH X: ENTRY DELAY
1(YES) 2(NO)
(b) Proceed with (i) if you wish to program an entry delay.
(c) Proceed with (ii) if you do not.
(i) To program an entry delay, press “1”.
(ii) The LCD will read: ENTER 0-199 THEN
PRESS *
(iii)Press “1” to program a delay. Then enter the digits corresponding
to the number of seconds you wish to install. (For example, press
“90” then press “*”, if you wish to install a 90-second delay).
(d) If you do not wish to program an entry delay, press “2”.
i) Normally Open/Normally Closed
1. STEP 6 The LCD will read: CH X: N.O./N.C.
1(N.O.) 2(N.C.)