Xylem CVD-2000 CELLULAR AUTODIALERS - Manual (Page 16)

Global Water
800-876-1172
• globalw.com
- 16 -
(a) Press “1” to select a normally open channel.
(b) Press “2” to select a normally closed channel.
j) Momentary/Continuous Activation
1. STEP 7 The LCD will read: CH X: MOM/CONT
1(MOM) 2(CONT)
(a) Press “1” to select a momentary trigger.
(b) Press “2” to select continuous activation.
k) Numbers Dialed/Outgoing Messages
Following these steps allows you to choose which OGM(s) will be delivered and
which numbers will be dialed for each channel.
NOTE: Dialer LCD will only show programmed numbers and OGM options.
1. STEP 8 The LCD will read: CH X: DIAL #X
1(YES) 2(NO)
“Dial #X” being the number in phone/pager location 1-8)
(a) Press “1” to dial phone/pager #X to be dialed when the selected
channel is activated. Press “2” if you do not wish this number to be
dialed.
(b) Continue the above procedure for each of the up to eight phone/pager
numbers programmed in.
2. STEP 9 The LCD will read: CH X: OGM X
1(YES) 2(NO)
(“OGM X” being the OGM recorded in OGM options #2 - #8)
(a) Press “1” to deliver OGM X when the channel is activated. Press “2”
if you do not wish this OGM to be delivered.
(b) Continue the above procedure for each Channel/OGM. If you have
programmed in and recorded an ID message as one of your OGM
options, this ID will be delivered to all channels. It will not appear in
the Channel display.
NOTE: ID AND OGM(S) WILL ONLY BE DELIVERED TO
TELEPHONE NUMBERS, CELLULAR NUMBERS, AND
VOICE PAGERS.
l) Completing The Programming
Once you have programmed in all dialing and OGM options for each channel, the
LCD will read: ACCEPT
1(YES) 2(NO)
1. STEP 10 Press “1” to accept the Channel programming. Press “2” to re-
program or to revert to previously programmed setting. You are now ready
to review your programming and test the system.
PRESS “M” TO EXIT PROGRAMMING MODE.