Xylem CVD-2000 CELLULAR AUTODIALERS - Manual (Page 9)

Global Water
800-876-1172
• globalw.com
- 9 -
b) Programming Telephone and/or Pager Numbers
First Time Installation to Initialize Dialer Follow Steps 1 & 2.
1. Apply power to the unit.
•
The LCD will read: NOT PROGRAMMED
PRESS KEYPAD #1
2. Press 1.
•
The LCD will change to read: USP AD200-4 X.X
•
Then: PROGRAM: NUMBERS
•
Then: SELECT: 1-8
•
0(DONE)
3. You are now ready to begin programming the dialer. All programming can
be input before connecting the dialer to a telephone line. Check the unit’s
LCD as you program numbers in the dialer to ensure accuracy. Please
complete all programming instructions before attempting to operate the
unit.
Before programming your dialer to call the police, fire department, or
9-1-1 directly, you must check with these agencies for their approval.
A maximum of 50 digits (including pauses) can be programmed in at each
location.
*PROGRAM: NUMBERS SELECT: 1-8
1(YES) 2(NO )
0(DONE)
*This prompt will appear after a number has been programmed and this section
has been exited.
1. Step 1 - Press location number 1-8 to program the first number. This can
be any location 1-8. You do not have to program locations in sequence.
For example, you can program numbers in locations 3 and 5. When you
are done programming all the desired telephone and/or pager
numbers, press “O” to exit this section.
The LCD will read: PAGER
1(YES) 2(NO)
2. Step 2 - Press “1” if you wish to program in a numeric pager number (step
3A). Press “2” if you wish to program in a telephone number (step 3B),
cellular phone number (step 3B), or a voice pager (step 3C).
3. STEP 3A - NUMERIC PAGERS NOTE: WHEN PROGRAMMING
NUMERIC PAGERS, YOU MUST PROGRAM IN ONE OR MORE
PAUSES. EACH “P” PROVIDES A 2- SECOND PAUSE. BEFORE
PROGRAMMING IN A PAGER, CALL THE NUMBER TO
DETERMINE THE NUMBER OF 2-SECOND PAUSES TO BE