Xylem CVD-2000 CELLULAR AUTODIALERS - Manual (Page 21)

Global Water
800-876-1172
• globalw.com
- 21 -
the third phone number in location 6; press “1” to indicate numeric pager;
then press, in sequence, “3456789PP5544#” followed by the “*” sign.
4. STEP 4 Press “0” to exit PROGRAM NUMBERS.
5. STEP 5 At the PROGRAM: T-LINE prompt, press “1” to choose tone;
press “2” to indicate no PBX; press “2” to program in two dialing attempts
per emergency number called; press “2” to program in two message
repeats for each call.
6. STEP 6 Press “1” to PROGRAM OGM(S). Press “2” three times to Scroll
to option #4; press “1” to program in an ID message and two specific
outgoing messages (OGMs).
7. STEP 7 Using a prepared script and speakin g six-to-eight inches from the
dialer’s microphone on the front of the unit, press “R” when you are ready
to enunciate your 15-second identification message and your two 18-
second messages. Dialer automatically prompts to next OGM. Make
OGM1 a message telling the receiving party to call the police department.
Make OGM2 a message to call the fire department.
8. STEP 8 Press “1” to play back all recorded messages; press “1” again to
accept. (NOTE: DIALER LCD WILL ONLY SHOW
PROGRAMMED NUMBERS AND OGM OPTIONS).
9. STEP 9 Press “1” to PROGRAM CHANNELS.
10. STEP 10 Press “1” to program Channel 1. Press “1” to ENABLE. Press
“1” then enter “30” then press “*” for a 30-second EXIT delay; press “1”
then enter “15” then press “*” for a 15-second entry delay. Now press “2”
for NORMALLY CLOSED and then “1” for MOMENTARY activation.
Press “1” to select phone/pager number 1 to be dialed. Press “1” again to
select phone/pager number 5 to be dialed. Press “2” to not select
phone/pager number 6 to be dialed. Press “1” to select OGM1 to be
delivered and press “2” to not select OGM2 to be delivered. Press “1” to
accept the channel configuration.
11. STEP 11 Press “4” to program Channel 4. Press “1” to ENABLE. Press
“2” twice to indicate no EXIT or ENTRY delay. Now press “1” for
NORMALLY OPEN and the “2” for CONTINUOUS activation. Press “1”
to select phone/pager number 1 to be dialed. Press “2” to not select
phone/pager 5 to be dialed. Press “1” to select phone/pager number 6 to be
dialed. Press “2” to not select OGM1 to be delivered and press “1” to
select OGM2 to be delivered. Press “1” to accept the channel
configuration.