Xylem CVD-2000 CELLULAR AUTODIALERS - Manual (Page 19)

Global Water
800-876-1172
• globalw.com
- 19 -
Under a momentary activation, a single violation of a channel will cause the dialer
to initiate delivering all preselected OGMs to all programmed numbers associated
with that channel. Under continuous activation, the dialer will initiate the process,
terminating it if/when the activated channel is restored to a non-alarm state. Once
an alarm has occurred and all attempts satisfied, the dialer will continue to
monitor any remaining enabled channel(s). Once the activated channel has been
restored to a non-alarm state, it will then be re-armed and ready for the next
alarm.
c) Exit/Entry Delays
If a channel is activated during a pre-selected exit delay, the alarm condition will
be ignored until the delay has expired. If an alarm occurs, the entry delay will
cause the dialer to wait before starting the dialing process. To de -activate the
dialer during the entry wait period, simply press “M” to return to the OFF
Mode. Both exit and entry delay times can be pre-selected to range from 1-199
seconds.
d) Additional features
The dialer offers three innovative features that enhance the utility of the entire
system.
e) Listen-In
While receiving an OGM on a touch-tone phone, the called party can press “1” to
listen in to the activity at the other end of the line for one minute. Pressing “1”
again restarts the minute increment period and can be repeated indefinitely. When
“1” is pressed the OGM will stop playing and the listen in period will start.
f) Two -Way After the called party is listening- in, that party can press “2” to begin a
two-way conversation lasting for one minute. This procedure also can be repeated
indefinitely by pressing “2” again to restart the minute. Once you are in two-way
mode you cannot go back to Listen-In.
g) Remote Turn-Off The called party can remotely terminate the activated channel
any time during the OGM by pressing “1” then “#” twice within one second. The
dialer will continue to monitor the remaining channel(s). Once the terminated
channel is restored to a non-alarm state, it will re-arm. If in listen- in or two-way,
simply press “#” twice in one second, for remote turn-off.