Extron Electronics IPCP 505 User Guide - Manual (Page 13)

IPCP 505 • Hardware Features and Installation 7
Hardware Features
and Installation
This section covers the following material:
• Setup Checklist: How to Proceed With Installation — A checklist of tasks to guide
you through installation
• Front Panel Features — Locations and some descriptions of items on the front panel
• Mounting the IPCP 505 — Brief guidelines for mounting
• Rear Panel Features and Connections — Locations, descriptions, and cabling notes
for rear panel features and corresponding front panel indications
• Resetting the Unit — Information about the available reset modes and how to reset
the IPCP
Setup Checklist:
How to Proceed With Installation
Prepare
Familiarize yourself with the features of the IPCP 505.
Install the latest version of the Extron Global Configurator (GC) software (version 3.2 or
higher), the latest driver package, and any additional software such as GUI Configurator,
GlobalViewer Enterprise (GVE) or IR Learner (available from
www.extron.com or the
Extron Software Products disc).
Obtain IP setting information from the network administrator for the IPCP.
Obtain model names and setup information for devices that the IPCP will control.
Perform Physical Installation
Mount the unit to a rack or projector mount (see the instructions on page 10).
Connect the IPCP 505 to a network (LAN) and connect other devices to the IPCP (see
Rear Panel Features and Connections starting on page 11 or see the “Setup”
section of the IPCP 505 Setup Guide).
Connect power cords and turn on the output devices (projectors, monitors, speakers),
the IPCP, a PC (for setup) or touchpanel (for control after configuration), and input
devices (DSS, cable boxes, and the like).
Configure the IPCP
Connect the PC and the IPCP 505 to the same Ethernet network (see page 13) and
use Telnet, Extron DataViewer, or a similar application to configure the IPCP for network
communication.
Connect any Extron TLP touchpanels that will be part of the system to the same network
as the PC and IPCP. Create a user interface layout for the touchpanels and upload the
GUI configuration to each touchpanel. See the GUI Configurator Help file for instructions.