Dsp configurator program, Starting the program – Extron Electronics MVC 121 Plus User Guide User Manual
Page 49
Advertising
2.
The USB driver installer is launched. When the installer has completed the installation
of the USB drivers, the following screen appears:
Figure 23.
Successful USB Driver Installation
3.
Click
Finish
.
USB driver installation is complete.
DSP Configurator Program
Starting the Program
1.
To run the DSP Configurator Program, click
Start > Programs > Extron Electronics > DSP Configurator > DSP
Configurator
.
The DSP Configurator program starts in
Emulate
mode (see to
MVC 121 Plus • Software Control
43
Advertising