Extron Electronics MVC 121 Plus User Guide - Manual (Page 52)

Selecting Live Mode and Pushing or Pulling a Configuration
To switch from emulate mode to live mode:
1. Click the Mode Live button (see item a below). The Connect to device dialog box
opens.
or
MVC 121 Plus
1
4a
4b
3a
3b
3c
2 2
Figure 25. Selecting Live Mode
2. If necessary and as desired, click either the:
• RS-232 tab (for connection to the rear panel RS-232 ports — proceed to step 3).
• USB tab (for connection via the front panel configuration port — proceed to
step 4).
3. If RS-232 was selected in step 2:
a. Click the com port drop-down menu and select the PC comm port connected to
the rear panel RS-232 port.
b. Check the baud rate displayed in the comm port selection window. If the baud
rate does not match the device rate, click the Baud Rate drop-down menu and
select the desired baud rate. The default is 38400.
c. Click OK .
The Synchronize with Device dialog box (figure 26) appears. Proceed to step 5.
4. If USB was selected in step 2:
a. Click the USB Device drop-down menu and select MVC 121 (or Extron USB
device , if MVC 121 is not available),
b. Click OK .
The Synchronize with Device dialog box (figure 26) appears. Proceed to step 5.
5. Click either the:
a. Pull radio button to configure the DSP Configurator program to match
the device — proceed to step 6
-or-
b. Push radio button to configure the device to match the DSP Configurator
program — proceed to step 6
MVC 121 Plus • Software Control 46