Extron Electronics MTPX Plus Series Setup Guide - Manual (Page 12)

3-2
Refer also to the MTPX Plus User’s Manual at www.extron.com .
3-3
Refer also to the MTPX Plus User’s Manual at www.extron.com .
The key shown at right applies
to all drawings in this chapter.
Creating a Tie
A "tie" is an input-to-output connection.
A "set of ties" is an input tied to two or more outputs. (An
output can never be tied to more than one input.)
A "configuration" is one or more ties, one or more sets of ties, or
a combination.
1
. Press and release the Esc button to clear any input button,
output button, or control button indicators that may be lit.
2 . Press and release the Video and/or Audio I/O button(s) to
select or deselect video and/or audio as desired.
Green when selected
Off when deselected
Red when selected
Off when deselected
I / O
VIDEO AUDIO
N Audio (RS-232) or video can be broken away (tied by itself)
by selecting only the Video button or only the Audio
button.
3 . Press and release the desired input button.
5
The button lights to indicate the selection.
4 . Press and release the desired output buttons.
3 4
ENTER
8
Amber indicates video and audio tie.
Green indicates video only tie.
Red indicates audio only tie.
Green indicates the
need to confirm the
change.
5 . Press and release the Enter button. All button indicators
turn off.
Saving or Recalling a Preset
A "preset" is a configuration that has been stored.
1
. Save a preset — Press and hold the Preset button until it
flashes.
Recall a preset — Press and release the Preset button.
PRESET PRESET
PRESET PRESET
Preset button blinks. Press and hold.
2 seconds Save a
preset
Recall a
preset
Preset button lights. Press and release.
All input and output buttons with
assigned presets light
red.
The configuration data at assigned
preset locations will be overwritten.
INPUTS
1 2 3 4 5 6 7
2 . Press and release the desired input or output button.
1
ENTER
The button blinks red to indicate that
this preset is selected to save or recall.
The Enter button blinks
red to indicate the need to
activate the save or recall.
3 . Press and release the Enter button.
= lit, = unlit = blinking,
= lit, = unlit = blinking, = lit, = unlit = blinking,
MTPX Plus Series • Front Panel Operation
Front Panel Operation
MTPX Plus Series • Front Panel Operation