Brickcom OSD-200 20xp - Manual (Page 43)

39
Enter the IP address of the management server.
c. Trap community
Enter the community to use when sending a trap message to the
management system.
d. Trap Option
 Warm Start
A Warm Start SNMP trap signifies that the SNMP device, i.e. IP
Camera, performs software reload.
Click on <Save> button when complete.
7.3.4 UPnP
The UPnP setting can be found under this path: System> Network>
UPnP.
A. UPnP Setting
a. Enable UPnP
When the UPnP is enabled, whenever the IP Camera is presented to
the LAN, the icon of the connected IP Cameras will appear in My
Network Places to allow for direct access.
NOTE- To enable this function, please make sure the UPnP
component is installed on the computer. Please refer to Install UPnP
components for UPnP component installation procedure.
 Enable UPnP port forwarding
When the UPnP port forwarding is enabled, the IP Camera is
allowed to open the web server port on the router automatically.
NOTE- To enable this function, please make sure that the router
supports UPnP and it is activated.
 Friendly name
Set the name for the IP Camera for identity.
7.4 DDNS
The DDNS setting can be found under this path: System> DDNS.