Brickcom OSD-200 20xp - Manual (Page 56)

52
Pre-trigger buffer recording function allows users to check what
happened to cause the trigger. The pre-trigger buffer time range is from
1 to 3 seconds. Select <Upload for __ sec> to set the recording duration
after alarm is triggered. The setting range is from 1 to 99999 seconds.
Select <Upload during the trigger active> to record the triggered video
until the trigger is off.
NOTE- Please make sure the local recording (with Micro SD /
SDHC card) is activated so that this function can be implemented.
Refer to Recording for further details.
F. Send Alarm Message by FTP/E-Mail
The Administrator can select whether to send an alarm message by
FTP and/or E-Mail when an alarm is triggered.
G. Save
Click on the <Save> button to save all the settings mentioned above.
7.11 Storage Management (Local Recording)
The Storage Management setting can be found under this path: System>
Storage Management.
Users can implement local recording to the Micro SD / SDHC card up to
32GB. This page shows the capacity information of the Micro SD card and a
recording list with all the recording files saved on the memory card. Users
can also format the SD card and implement automatic recording cleanup
through the setting page.
To implement Micro SD card recording, please go to the <Recording> page
(refer to the section Recording ) for activation.
NOTE- Please format the Micro SD / SDHC card when using for the
first time. Formatting will also be required when a memory card already
being used on one camera and later transferred to another camera with
different software platform.