Brickcom OSD-200 20xp - Manual (Page 67)

63
The Video Frame Rate setting can be found under this path: Streaming>
Video Frame Rate. It is for setting the frames per second (fps) if necessary.
A. MJPEG / H.264-1 / H.264-2 / H.264-3 / H.264-4 Frame Rate
The default setting of MJPEG / H.264-1 / H.264-2 / H.264-3 / H.264-4
Frame Rate is 30 fps; the setting range is from 1 to 30.
Click on <Save> to confirm the setting.
NOTE- A lower frame rate will decrease the video smoothness.
8.5 Audio (Audio Mode and Bit Rate Settings)
The audio setting can be found under this path: Streaming> Audio.
In the Audio page, the Administrator can select the transmission mode and the
audio bit rate.
A. Transmission Mode
a. Full-duplex (Talk and listen simultaneously)
In the Full-duplex mode, the local and remote sites can communicate
with each other simultaneously, i.e. both sites can speak and listen
at the same time.
b. Half-duplex (Talk or listen, not at the same time)
In the Half-duplex mode, the local / remote site can only talk or listen
to the other site at a time.
c. Simplex (Talk only)
In the Talk only Simplex mode, the local site can only talk to the
other site, and cannot listen to the other site.
d. Simplex (Listen only)
In the Listen only Simplex mode, the local site can only listen to the
other site, and cannot talk to the other site.
e. Disable