CHIEF Short Throw Interactive Series - Manual (Page 10)

WM210-220-230-240S/SI Installation Instructions
10
5. Install four 5/16 x 2-1/2" hex head lag screws (L) through
four 5/16" washers (M), holes of wall bracket and into drilled
holes. (See Figure 7)
Figure 7
Steel Studs
IMPORTANT ! : See Site Requirements section before
proceeding with Steel Studs installation to ensure
installation site meets requirements! The drywall must
have a minimum thickness of 1/2"!
1. Determine mounting location on wall. Use stud finder to
locate steel studs. For studs less than 16" apart, wall
bracket will have to be adjusted. See appropriate
Adjustments section for details.
2. Line up four holes on wall bracket with center of studs at
desired mounting location. (See Figure 8)
3. Using wall bracket as a template, mark four holes at the
inner four holes in bracket. (See Figure 8)
4. Drill four 1/2" holes at marked locations in wall. (See Figure 8)
Figure 8
5. Hold metal channel on anchor (P) flat alongside plastic
straps and slide channel through hole. (See Figure 9)
Figure 9
6. Holding plastic straps on anchor (P), pull anchor away from
wall until channel rests flush behind wall making sure anchor
channel is positioned vertically on stud. (See Figure 10)
7. Slide plastic cap on anchor (P) towards wall until flange of
cap is flush with wall. (See Figure 10)
Figure 10
8. Snap off plastic straps on anchor at wall by pushing side to
side, snapping off straps level with flange of plastic cap.
(See Figure 11)
9. Repeat Steps 6 through 8 for each mounting hole.
Figure 11
(L) x 4 5
(B)
(M) x 4
(front view)
(B)
Steel studs
3
4
x 4
x 4
(P) x 4
Drywall
Plastic straps
5
(P) x 4
Plastic cap
Drywall
Anchor metal channel
7
Steel stud
(side view)
6
Plastic straps
Drywall
Anchor metal channel
Plastic cap
8
Steel stud
(side view)