CHIEF Short Throw Interactive Series - Manual (Page 12)

WM210-220-230-240S/SI Installation Instructions
12
4. Loosen two bolts on either side of pitch adjustment screw.
(See Figure 16)
5. Adjust pitch adjustment screw until mount is at desired pitch
level. Turn clockwise to raise mounting level or turn
counterclockwise to lower mounting level. (See Figure 16)
6. Tighten two bolts on either side of pitch adjustment screw.
(See Figure 16)
Figure 16
7. Tighten two bolts installed in Step 3. (See Figure 15)
Projector Installation
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the short throw projector mounts
up to (and including) the projector does not exceed 50 lbs
(22.68 kg) for the WM210S/SI or the WM220S/SI or 25 lbs
(11.34 kg) for the WM230S/SI or WM240S/SI.
NOTE: RPM, RPA and RSA are sold separately.
Figure 17
NOTE: Determine hole configuration to use for each specific
projector mount. (See Figure 17)
RPM Installation
1. Line up mounting holes on RPM mount with corresponding
holes on projector mounting plate. (See Figure 17)
2. Install four 1/4-20 x 1-1/2" Phillips pan machine screws (H)
through RPM holes and into projector mounting plate. (See
Figure 18)
Figure 18
3. Install interface and projector to RPM according to RPM
installation instructions.
RSM (not evaluated and tested by Underwriters
Laboratories®) Installation
1. Line up mounting holes on RSM mount with corresponding
holes on projector mounting plate. (See Figure 17)
2. Install four #10-24 x 1-3/8" Phillips pan machine screws (J)
through RSM holes and into projector mounting plate. (See
Figure 19)
Figure 19
3. Install interface and projector to RSM according to RSM
installation instructions.
4 6
5
or
raise lower
(bottom view)
RPM RPA
RSM
RSA
RPM
Mounting plate
(H) x 4 2
Mounting plate
RSM
(J) x 4 2