CHIEF Short Throw Interactive Series - Manual (Page 22)

WM210-220-230-240S/SI Installation Instructions
22
4. Remove cable management covers (if necessary) from
short throw projector arm. (See Figure 55)
Figure 55
NOTE: Cables may be routed from below and up wall bracket
channel, or from above and down behind and into wall
mount.
• Routing Cables from Below (Steps 5 and 6)
5. Open cable clips along bottom edge of wall bracket. (See
Figure 56)
Figure 56
6. Thread cable up wall bracket channel and into opened
cable clips. (See Figure 57) Proceed to Step 8
Figure 57
• Routing Cables from Above (Step 7)
7. Thread cables down through a surface mount cable
accessory (not included), then behind and into the wall
bracket. (See Figure 58) Proceed to Step 8
Figure 58
(bottom view)
4
4
Cable
management
covers
cable clips
x 4
5
Cables (example)
(view from back)
(view from front)
Surface Mount
Cable Accessory
(not included)
Cables
Cables
7
7