CHIEF Short Throw Interactive Series - Manual (Page 15)

Installation Instructions WM210-220-230-240S/SI
15
NOTE: Cables may be routed from below and up wall bracket
channel, or from above and down behind and into wall
mount.
• Routing Cables from Below (Steps 6 and 7)
6. Open cable clips along bottom edge of wall bracket. (See
Figure 28)
Figure 28
7. Thread cable up wall bracket channel and into opened
cable clips. (See Figure 29) Proceed to Step 9
Figure 29
• Routing Cables from Above (Step 8)
8. Thread cables down through a surface mount cable
accessory (not included), then behind and into the wall
bracket. (See Figure 30) Proceed to Step 9
Figure 30
9. Route cables through cover mount, projector arm tunnel
and into projector. (See Figure 31)
Figure 31
cable clips
x 4
6
Cables (example)
(view from back)
(view from front)
Surface Mount
Cable Accessory
(not included)
Cables
Cables
8
8
Cable clips
Cables (example)