Mounting wall bracket – CHIEF Short Throw Interactive Series User Manual
Page 9
Installation Instructions
WM210-220-230-240S/SI
9
ASSEMBLY AND INSTALLATION - (WM2XXSI
and WM2XXS MODELS)
The WM-210S/SI, -220S/SI, -230S/SI and -240S/SI short throw
projector mounts can be mounted to concrete, concrete block,
wood studs or steel studs. They can be mounted to 2" x 4"
wood studs up to 16" apart. For studs more than 16" apart, the
WMAL24 accessory (not evaluated and tested by Underwriters
Laboratories®) can be used to mount projector.
WARNING:
ELECTRICAL SHOCK HAZARD! CUTTING
OR DRILLING INTO ELECTRICAL CORDS OR CABLES
CAN CAUSE DEATH OR SERIOUS PERSONAL INJURY!
ALWAYS make certain area behind mounting surface is free
of electrical wires and cables before cutting, drilling, or
installing fasteners.
WARNING:
EXPLOSION AND FIRE HAZARD! CUTTING
OR DRILLING INTO GAS PLUMBING CAN CAUSE DEATH
OR SERIOUS PERSONAL INJURY! ALWAYS make certain
area behind mounting surface is free of gas, water, waste, or
any other plumbing before cutting, drilling, or installing
fasteners.
Mounting Wall Bracket
Concrete or Concrete Block
1.
Determine mounting location on wall.
2.
Using wall bracket (B) as a template, mark four holes at the
holes in bracket. (See Figure 4)
3.
Drill four 3/8" holes at marked locations in wall. (See Figure 4)
Figure 4
4.
Install four concrete anchors (K) into drilled holes. (See
Figure 5)
5.
Install four 5/16 x 2-1/2" hex head lag screws (L) through
four 5/16" washers (M), outer holes of wall bracket (B) and
into concrete anchors (K). (See Figure 5)
Figure 5
Wood Studs
WARNING:
The wall to which the mount is being attached
may have a maximum drywall thickness of 5/8" (1.6cm). Do
not install drywall anchors into the seam between drywall
pieces.
1.
Determine mounting location on wall. Use a stud finder to
locate 2" x 4" wood studs. For studs less than 16" apart,
mounting brackets will have to be adjusted. See appropriate
Adjustments section for details.
2.
Line up inner four holes on wall bracket (B) with center of
studs at desired mounting location. (See Figure 6)
3.
Using wall bracket (B) as a template, mark four holes at the
holes in bracket. (See Figure 6)
4.
Drill four 7/32" holes at marked locations in wall. (See
Figure 6)
Figure 6
2
3
x 4
x 4
(front view)
(B)
(B)
(L) x 4
5
(K) x 4
4
(M) x 4
(front view)
(B)
Wood studs
3
4
x 4
x 4