CHIEF Short Throw Interactive Series - Manual (Page 16)

WM210-220-230-240S/SI Installation Instructions
16
10. (Optional) Cables can be tied to inside of mount’s front
cover using cable ties (not included). Route cables near
front cover and wrap cable tie through slots on front cover
and around cables. (See Figure 32)
Figure 32
11. Replace removed cable management covers (if necessary).
Insert one side of cover into groove and press firmly on the
cover on the other side until it snaps into the other groove.
(See Figure 33)
Figure 33
12. Return outer covers to the mount following instructions in
Installing Mount Covers section.
Installation of Wall Bracket Covers
NOTE: If security screws are going to be used, use the security
screws (V) to install wall bracket covers. See Security
Screw Installation section for details.
1. Place wall bracket top caps (C) over top of each wall bracket
arm. (See Figure 34)
Figure 34
2. Secure wall bracket top caps (C) to wall bracket arms by
installing four #8-32 x 1/2" Phillips pan machine screws (F)
through holes in covers and wall bracket. (See Figure 35)
3. Place wall bracket bottom caps (D) over bottom of each wall
bracket arm. (See Figure 34)
4. Secure wall bracket bottom caps (D) to wall bracket arms by
installing four #8-32 x 1/2" Phillips pan machine screws (F)
through holes in covers and wall bracket. (See Figure 35)
Figure 35
Cable tie (not included)
Route through slots and
around cables
10
11
(C) x 2
(D) x 2 3
1
(Projector arm not shown
for display purposes)
2
(F) x 4
4 (F) x 4
(Projector arm not shown
for display purposes)