CHIEF Short Throw Interactive Series - Manual (Page 21)

Installation Instructions WM210-220-230-240S/SI
21
WM2XXS STANDARD MOUNT
Installing Mount Covers
1. Raise the lower cover (AK) to wall mount and hold in place.
(See Figure 51)
Figure 51
2. Lower the upper cover (AJ) onto the wall mount and fasten
through upper cover (AJ), lower cover (AK) and into wall
mount with two 8-32 x 1/2" Phillips pan head screws (F).
(See Figure 52)
Figure 52
Cable Management (Optional)
In most cases, cable management covers will NOT need to be
removed in order to route cables from projector to the wall
mount. But for some thick cables, removing the covers may be
necessary.
Removing Mount Covers
1. Remove and save two 8-32 x 1/2" Phillips pan head screws
from upper cover. (See Figure 53)
2. Raise upper cover away from the mount. (See Figure 53)
Figure 53
3. Remove lower cover from mount. (See Figure 54)
Figure 54
1
(AK)
2
2 (F) x 2
(AJ)
1 (F) x 2
2
3