AMX Mio Modero R-4 - Manual (Page 13)

Mio R-4 Setup
5 Mio Modero R-4
Mio R-4 Setup
Installing or Replacing the Mio R-4 Lithium-Ion Battery
To install your lithium-ion battery into the Mio R-4:
1. Flip and turn the Mio R-4 so that the buttons are facing away from you and the device is upside
down.
2. Holding the device in both hands, place your thumbs on the battery door and slide the battery door
free. The battery door should slide toward the bottom end of the device.
3. Connect the terminal end of the Lithium Ion battery to the port shown in FIG. 2. It may be necessary
to use a thin, blunt non-conductive object to seat the battery connector fully within its port.
4. Place the battery door back on the device, and slide the door upwards to lock it in place.
FIG. 2 Rechargeable Battery Port on The Mio Remote
Lithium-Ion Battery
Rechargeable
Battery Port
Connection
Rear view -
battery compartment
Programming Port
(USB)
Correct path for
battery wires and
connector
Make sure that the battery wires run alongside the battery in the compartment as
shown in FIG. 2. Otherwise, the wires may be damaged or the battery door may not
close properly.