AMX Mio Modero R-4 - Manual (Page 51)

Programming the Mio R-4
43 Mio Modero R-4
Page Commands (Cont.)
@PHT
Set the hide effect
time for a popup
page
Set the hide effect time for the specified popup page.
Syntax:
SEND_COMMAND <DEV>,"'@PHT-<popup page name>;<hide effect time>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the page the popup is displayed
On.
• hide effect time = Given in 1/10ths of a second.
Example:
SEND_COMMAND Device,"'@PHT-Popup1;50'"
Sets the Popup1 hide effect time to 5 seconds.
@PPA
Close all popups
on a page
Close all popups on a specified page. If the page name is empty, the current page is used.
This command works in the same way as the 'Clear Page' command in TPDesign4.
Syntax:
SEND_COMMAND <DEV>,"'@PPA-<page name>'"
Variable:
• page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
Example:
SEND_COMMAND Device,"'@PPA-Page1'"
Close all popups on Page1.
@PPF
Deactivate a
popup page
Deactivate a specific popup page on either a specified page or the current page. If the
page name is empty, the current page is used (see example 2). If the popup page is part
of a group, the whole group is deactivated. This command works in the same way as the
'Hide popup' command in TPDesign4.
Syntax:
SEND_COMMAND <DEV>,"'@PPF-<popup page name>;<page name>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the popup page.
• page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
Example 1:
SEND_COMMAND Device,"'@PPF-Popup1;Main'"
Deactivates the popup page 'Popup1' on the Main page.
Example 2:
SEND_COMMAND Device,"'@PPF-Popup1'"
Deactivates the popup page 'Popup1' on the current page.
@PPG
Toggle a popup
page
Toggle a specific popup page on either a specified page or the current page. If the page
name is empty, the current page is used (see example 2). Toggling refers to the activating/
deactivating (On/Off) of a popup page. This command works in the same way as the

'Toggle Popup' command in TPDesign4.
Syntax:
SEND_COMMAND <DEV>,"'@PPG-<popup page name>;<page name>'"
Variables:
• popup page name = 1 - 50 ASCII characters. Name of the popup page.
• page name = 1 - 50 ASCII characters. Name of the page the popup is displayed On.
Example:
SEND_COMMAND Device,"'@PPG-Popup1;Main'"
Toggles the popup page 'Popup1' on the 'Main' page from one state to another (On/Off).
Example 2:
SEND_COMMAND Device,"'@PPG-Popup1'"
Toggles the popup page 'Popup1' on the current page from one state to another (On/Off).