AMX Mio Modero R-4 - Manual (Page 33)

Protected Settings Menu
25 Mio Modero R-4
System Settings
The System Settings pages (FIG. 18) provide you with the connection status, gateway selection, and RF
link information. Use the device’s up and down arrows to move from page to page.
Checking connection status
1. Select Protected Settings in the Setup Menu.
2. Select System Settings in the Protected Settings Menu. If the round button at the top right of the first
page is green, the system is connected.
3. Select the Back button until you are out of the Setup Menu.
Checking the master IP address
1. Select Protected Settings in the Setup Menu.
2. Select System Settings in the Protected Settings Menu. The master IP is indicated on the first page.
3. Select the Back button until you are out of the Setup Menu.
FIG. 18 System Settings Pages
Status
Status Green light indicates the overall connection is good.
Connected to System Shows the number of the connected system.
Master IP The IP of the connected master.
Icsp Mode The mode used for wireless communication. This is always defaulted to "ZigBee".
Device Number The number of the device in the NetLinx system.
Gateway IP The IP for the Gateway providing the connection.
Gateway EUI Address The EUI Address for the Gateway providing the connection.
Device EUI A ZigBee network ID unique to the device.
Extended PANID The ID for the ZigBee personal area network.
Network Scan This button opens the Site Survey page (FIG. 19).
ZigBee Diagnostic This button opens the ZigBee Diagnostics page (FIG. 20).