ALLIED Vision Technologies Goldeye P-032 SWIR - Manual (Page 16)

Specifications
Goldeye Technical Manual V2.5.0
16
Goldeye CL-008 SWIR/ Goldeye CL-008 SWIR
Cool
Note

The warranty becomes void because of unauthorized tamper-
ing or any modifications not approved by the manufacturer.
Timing changes (frame rates and exposure time) in this chapter
are valid starting SN 00102 (Goldeye P-032) or SN 00308
(Goldeye P-008).
Caution

Surge
To avoid damage caused by surge, connect the camera to an
AC/DC power supply. Use a certified industrial power supply
that complies with common industrial standards. Make sure
the polarization of the power supply is correct.
During the camera start-up, inrush currents ≥ 4 A can occur for
20 ms. Use a sufficiently dimensioned power supply to avoid
damage to the camera.
For the DC signal, use cable lengths less than 30 m. Consider
that the voltage drop increases with the cable length.
AVT (or your local dealer) provides suitable power supplies:
http://www.alliedvisiontec.com/emea/products/
accessories.html
Feature Specification
Sensor InGaAs sensor, progressive scan; electronic full-frame shutter
Effective chip size 9.6 mm (H) x 7.68 mm (V)
Cell size 30 μm x 30 μm
Resolution(max.) 320 (H) x 256 (V) full resolution
320 (H) x 160 (V) reduced resolution
Lens mount C-Mount
Spectral response 900 nm to 1700 nm (SWIR)
Frame rate up to 118 fps full resolution
up to 186 fps reduced resolution
Exposure time 5 μs to 100 ms / 5 μs to 1 s
Cooling Goldeye CL-008 SWIR Cool only:
Peltier cooled
+0 °C stabilized
ADC 14 bit
Table 4: Specification Goldeye CL-008 SWIR / Goldeye CL-008 SWIR Cool