ALLIED Vision Technologies Goldeye P-032 SWIR - Manual (Page 47)

Data interface
Goldeye Technical Manual V2.5.0
47
High-speed mode (CC2) Goldeye xy-008 only
If CC2 is logically 1, the camera works with a resolution of 320 x 256 pixels at
118 fps.
If CC2 is logically 0, the camera works with a reduced resolution of 320 x 160
pixels at 186 fps.
In both cases DVAL is set to 1 for one Camera Link clock cycle in each pixel cycle
of two clocks.
The DVAL signal has to be evaluated by the frame grabber, otherwise the effec-
tive resolution is 640 x 256 pixels or rather 640 x 160 (each pixel is horizontally
output for two times) independent of the CC2 state.
For more information about the DVAL signal and pixel multiplication back-
ground: see chapter
Timing (FVAL, LVAL, DVAL, PCLK) on page 49.
TriggerMode Modifies the trigger mode of the camera. When the trigger mode
is Off, the camera will generate frames independently. When the
trigger mode is On the camera is switched to the so called IOD
(Image On Demand) mode. In this mode the camera waits for an
external trigger signal or timer pulse generated by the internal
GigE interface. To control exposure and dark time trigger mode
must be switched to On.
ExposureMode Start or stop the internal exposure signal timer.
ExposureTime Sets the Exposure time (in microseconds).
ExposureTimeAbs Sets the Exposure time (in microseconds).
ExposureTimeGranularity Exposure time granularity.
ExposureTimeAbsMs Sets the Exposure time (in milliseconds).
DarkTime Sets the Dark time (in microseconds).
DarkTimeAbs Sets the Dark time (in microseconds).
DarkTimeGranularity Dark time granularity.
DarkTimeAbsMs Sets the Dark time (in milliseconds).
Feature Description
Table 22: Camera standard feature: AcquisitionControl