ALLIED Vision Technologies Goldeye P-032 SWIR - Manual (Page 96)

Appendix
Goldeye Technical Manual V2.5.0
96
CameraSpecialFeatures
Feature Description
AutoCalibrateOnce Start the automatic calibration once.
(k=0 command)
The processing of this command can take several seconds,
depending on the current image rate and the number of
correction data sets available.
AutoCalibrationMode Configure mode of the automatic calibration function.
( j=<value> command)
AutoCalibrationInterval Setup the automatic calibration interval. 0 = Calibrate one-time,
1..65535 = Calibrate every k*256 frames.
(k=<value> command)
CorrectionDataSet Number of the correction data set to activate.
(S=<value> command)
ReloadCameraSpecialFeatures Force a reload of all parameters from the CameraSpecialFeatures
section.
Table 51: Camera special feature: Calibration and correction data
Feature Description
SensorTemperatureState Camera sensor temperature state.
0 = The sensor temperature is OK.
1 = The sensor temperature is outside the optimum range.
SensorTemperatureStateReg Camera sensor temperature state register.
QuerySensorTemperatureState Query camera sensor temperature state.
(T=1 command)
Table 52: Camera special feature: Camera sensor temperature
Feature Description
HighSpeedMode Turn on or off the high-speed mode with reduced resolution
(320x256 @118 Hz / 320x160 @186 Hz)
Table 53: Camera special feature: High-speed mode