ALLIED Vision Technologies Goldeye P-032 SWIR - Manual (Page 38)

Camera interfaces
Goldeye Technical Manual V2.5.0
38
This connector is intended for the power supply as well as for controlling the
camera by the user.
Furthermore some output signals are available, showing the camera state.
Power supply (pin 1-4)
The camera requires 12 V +5% DC. Current consumption depends on model. See
chapter
Specifications on page 14.
Serial interface (pin 7, 8)
By use of the serial interface at pin 7 and 8 the camera can be controlled exter-
nally via a RS232 COM port.
A simple terminal program (e.g. HyperTerminal) is sufficient for manually con-
trolling the camera.
Mode input (pin 9)
The mode input provides a method for switching the camera between the con-
tinuous operation and image-on-demand (IOD) mode using an externally
applied signal. This input has the same function as the camera control signal
CC4. For more information: see chapter
IOD mode (CC4) on page 48.
9
Mode Input optocoupler
input
10 Trigger (Reset)
Input
- optocoupler
input
11 +
12 Exposure Output - optocoupler
output
13 +
14 Line Sync Out Active low
15 Frame Sync
Output
Out Active low
Pin Signal Direction Level Description
Table 18: Camera I/O connector pin assignment (Goldeye xy-...)