Hach-Lange SC 60 - Manual (Page 15)

11
Installation
To remove the sensor connector before inserting the controller
enclosure into the panel cut-out:
1. Disconnect the wires at terminal block J5, see Figure 19 on
page 23 .
2. Loosen and remove the nut securing the sensor connector
inside the enclosure. Remove the sensor connector and wires.
3. After the controller is in place in the panel, reinstall the sensor
connector and reconnect the wiring to terminal J5 as shown in
Figure 19 on page 23 .
Figure 8 Panel Mounting the Controller
1 Controller 7 Lock washer, ¼-inch I.D., (4) Cat. No. 8H1336
2 Gasket, Neoprene, panel mount,
Cat. No. 1000A4F3249-101 8 Hex nut (4), Cat. No. 5867300
3 Panel (maximum thickness is 9.5 mm ( 3 / 8 inch)) 9 Flat washer (4), Cat. No. 8H1346
4 Mounting Foot (2), Cat. No. 1000B4F3222 10 Pan head screw, M6 Ч 1 Ч 150 mm (4),
Cat. No. 5867600
5 Mounting bracket, controller, Cat. No. 1000C4F3217-101 11 It may be necessary to remove the sensor connector.
see procedure below.
6 Pan head screw (4), Cat. No. 5867400
1 2 3
4
5
6 7
8
11
9
8
10